The HP8 hydraulic power unit is designed to provide power for underwater hydraulic tools requiring a single 5gpm up to 8gpm.
- Electric start and all-electric control system with rotary switches
- All components are assembled for easy routine servicing
- Upper frame can be removed for more serious servicing
- Quartz hour meter in the control panel records engine run time
- Hydraulic pump mounted directly to the engine eliminating any misalignment and ensuring long life of the drive coupling
- In-tank hydraulic filter continuously cleans the hydraulic fluid and assures that refill fluid passes through the filter for a clean refill
- 35-Ah sealed, non-spill-able, no maintenance battery is located inside a covered compartment
- Pressure lubrication system with a pressure sensing switch that will shut down the engine, if the engine oil level is too low
- Manual throttle control
- Lift and latch handle
- 12" foam filled tires
- 12 vdc plug on some models
- System will deliver 1000 watts, continuous and 1500 watts intermittent power through GFCI (Ground Fault Circuit Interrupter) receptacles
Engine - 18 hp Briggs
Capacity - One 5 GPM/19 LPM Circuit or One 8 GPM/30 LPM Circuit
Length - 36" / 91.4 cm
Width - 23" / 58.4 cm
Height - 29.5" / 74.9 cm
Weight (Wet) - Single Circuit Briggs 330 lbs / 149.6 kg
Fuel Tank Capacity - 5.5 gallons / 20.8 liters
Estimated Gas Consumption Per Hour - 1.3 gallons / 4 liters
Hydraulic Reservoir Capacity - 3 gallons / 11 liters
Relief Valve Setting - 2100 psi / 145 bar
Max Relief Setting - 2500 psi / 172 bar
HTMA/EHTMA Category - Type 1 and 2
Nominal Pressure - 1500 psi / 103 bar
Max Pressure - 2000 psi / 138 bar
Guaranteed Sound Power Level - 101 dBA
Measured Sound Power Level - 99 dBA
Vibration Level - N/A
